Electrolux refrigerator SH error code
Refrigerator
Reviewed August 2025 · sources below
Electrolux SH means showroom or demo mode is active — lights and displays work but cooling is disabled. This is common right after delivery when the unit was sold from a floor model. Exit showroom mode before assuming a cooling failure.
Safe to keep using?
No safety issue
This is a status or lock code, not a hardware fault.
Likely causes
Showroom / demo mode is on — cooling is disabled until you exit showroom mode.
Check: Press Power or Start/Pause to clear the code, then restart the cycle.
Est. cost: $0–$0
Demo mode blocks heating or full cycles until disabled in the settings menu.
Check: Follow the manual steps to exit demo/Sabbath mode, then power-cycle if the code persists.
Est. cost: $0–$0
What it means
Showroom / demo mode is on — cooling is disabled until you exit showroom mode.
How to fix it
- Press and hold the + and - freezer temperature keys together for 5 seconds (common on Frigidaire/Electrolux).
- If that does not work, check your manual for Demo or Sb mode exit — often a combination of alarm + down key.
- Power off at the breaker for 1 minute after exiting demo mode, then confirm the compressor starts.
- Verify both doors seal and the unit is not in a heated garage above rated ambient.
- If SH returns after exit, the control may need a factory reset per the service manual.
Call a pro when: Call a technician if cooling does not start after confirmed demo exit and 30 minutes of runtime.
Repair videos
FAQ
What does SH mean on a Electrolux refrigerator?
SH is showroom mode — cooling is turned off for store display. Exit demo mode to restore normal operation.
How do I turn off SH on Electrolux?
Hold + and - on the freezer keypad for 5 seconds, or follow the demo-mode exit in your manual.
Will SH damage the fridge?
No — but food will spoil because cooling is disabled. Exit showroom mode immediately.
Is SH the same as demo mode?
Yes — SH disables the compressor while keeping interior lights and controls active.
Electrolux SH on specific models
Other Electrolux Refrigerator codes
Prevent this problem next time
- Use lock features only when needed
- Avoid cutting power mid-cycle
Sources
Manufacturer meaning
Showroom / demo mode is on — cooling is disabled until you exit showroom mode.
FixApplianceCode guidance
Clear the SH status code and restart. No replacement part is needed.
Source type: Editorial
Source: FixApplianceCode status-code guidance
Last reviewed: 2026-08-24
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FixApplianceCode may earn a commission when you purchase through qualifying links, at no additional cost to you. Affiliate disclosure