Frigidaire error codes
Browse all known Frigidaire error codes. Pick your appliance, or click any code for fix steps and parts.
Dishwasher error codes
- E10Water fill timeout.
- E20Drain error.
- i10Low water level — the tub is not filling enough. Check the supply valve and inlet hose.
- i20Drain line restricted — clean the filter and straighten the drain hose.
- i30Leak detected in the bottom pan.
- i40Drain pump fault.
- i50Drain or wash motor failure.
- i60Heating element fault — water is not reaching wash temperature.
Dryer error codes
- E4ALong dry time — the cycle exceeded the program limit, usually from a clogged vent or oversized load.
- E5BHeater fault — the dryer is not heating. Check the vent, then the heating circuit.
- E24Thermistor error — the dryer cannot read air temperature.
- E25Thermistor error — the temperature sensor circuit is out of range.
- E68Stuck key on the electronic control — press each button firmly, then power-cycle.
Washer error codes
Refrigerator error codes
- SY EFEvaporator fan circuit fault (shown as SY EF or 5Y EF) — the freezer fan is iced or failed.
- SY CFCondenser fan circuit fault (shown as SY CF) — coils may be dirty or the fan motor failed.
- OPDoor open alarm — a door is ajar or the door switch is not reading closed.
- SHShowroom / demo mode is on — cooling is disabled until you exit showroom mode.
- CECommunication error between refrigerator control boards.
- SY CECommunication error between the display and the main board after the refrigerator has been running.
- 77Demo or showroom mode (display shows 77 77). The lights work and cooling is off until you unplug the refrigerator.
- SbSabbath mode is on. Lights, alarms, and some controls stay quiet until you exit Sabbath mode.
Oven / Range error codes
- F10Thermal runaway — the oven is hotter than it should be. Turn it off and let it cool.
- F30Open probe — the meat probe circuit is open or the probe is not seated.
- F90Door lock fault — the door will not lock or unlock for self-clean.
- F91Door lock circuit fault.
- F11Shorted keypad — a key is stuck down. Turn power off for 30 seconds. If F11 returns at startup, the oven control needs replacement.
- F12Bad micro identification — the oven control failed its identity check. Power off for 30 seconds. If F12 returns, replace the oven control.
- F13EEPROM checksum error — the control memory failed its check. Power off for 30 seconds. If F13 returns, replace the oven control.
- F14Flat cables between the touch panel and the oven control are misconnected. Reseat the ribbon cables, then restore power.
- F15Oven control self-check failed. Power-cycle once. If F15 returns, the control board needs replacement.
- F31Shorted oven temperature probe or its wiring. Check the probe circuit before replacing the control.
- F92Door-lock open time was exceeded. Check the latch motor, lock switch, and door switch.
- F93Door-lock time was exceeded while locking. Check the latch motor and lock switch.
- F94Door-lock attempts were exceeded. Check the latch motor and lock switch before replacing the control.