Bosch error codes
Browse all known Bosch error codes. Pick your appliance, or click any code for fix steps and parts.
Top Bosch error codes
Most searched codes with full fix guides and compatible parts.
Dishwasher error codes
Washer error codes
- E17Water supply issue — washer filling too slowly or not at all.
- E13Door lock fault — door not locking before cycle starts.
- E23Drain pump fault (often shown as E23) — washer unable to drain water.
- E25Water level sensor or Aquastop leak detected (often shown as E25).
- F17Door not locked — cycle cannot start.
- F21Motor fault — drum not turning properly.
Dryer error codes
- E01Lint filter is blocked and needs to be cleaned.
- E03Condensation drain hose is blocked or kinked.
- E04The dryer is overloaded — leave a hand's width of space above the clothes.
- E12Heat-pump limescale or overheating from restricted airflow — clean the lint screen and heat exchanger.
- E16Door was opened during the cycle — close it firmly and press Start.
- E56Moisture sensor error — clean the sensor bars inside the drum.
- E63Heating element failure — the dryer cannot produce heat.
- DRDoor is not closed or the door switch is not making contact.
- CrETime to run the basic appliance care program — this is a maintenance reminder, not a fault.
Refrigerator error codes
Oven / Range error codes
Cooktop error codes
- F1Cooking zone overheated and switched off to protect the work surface. Let it cool, then restart.
- F6Cooking zone overheated and switched off. Let it cool, then restart.
- F2Cooktop electronics overheated. The zone switched off until the board cools.
- F4Cooktop electronics overheated. Remove hot pans from the glass and wait.
- F5Hot cookware is sitting on the control panel — move the pan off the keys.
- F8Automatic time limit — the zone ran too long without a change. Touch any key to resume.
- E7010The cooktop cannot connect to the home network or the hood.
- E7015Electronics overheated — the zone switched off. Let it cool, then touch a control.
- E9010Supply voltage is outside the normal operating range.
- U400Supply voltage is incorrect — call the utility or an electrician.
- U1Input voltage is outside normal working limits.
- dEDemo mode is on (shown as dE) — zones will not heat. Reset the breaker, then touch a control.