Samsung error codes
Browse all known Samsung error codes. Pick your appliance, or click any code for fix steps and parts.
Top Samsung error codes
Most searched codes with full fix guides and compatible parts.
Washer7 codesDryer9 codesRefrigerator14 codesOven / Range7 codesDishwasher12 codesMicrowave10 codesCooktop3 codes
Washer error codes
Dryer error codes
- HCHigh temperature heating error — the dryer got too hot, often from a clogged lint screen or vent.
- HEHeating error — dryer not heating properly.
- tETemperature sensor fault — clean the lint filter and check for a restricted vent.
- 9C1Voltage error — the dryer is not getting the power it expects. Electric dryers need a dedicated 240V circuit.
- dCDoor is open or the latch is not secured — close the door firmly and clear laundry from the seal.
- CLChild lock is enabled — the control panel buttons are locked.
- CLGVent blockage test found a clogged exhaust — clean the lint filter and outdoor vent.
- oDDry time error — the load ran too long, usually from a clogged vent or an oversized load.
- FCPower frequency error — restart the cycle. If it returns, the supply frequency is out of range.
Refrigerator error codes
- nFIce maker fan or freezer fan issue.
- 1EIce maker error — harvest or fill cycle failed.
- OF FFreezer too warm — check door seal, evaporator fan, and airflow.
- 14EIce maker sensor error — the ice maker temperature reading is out of range.
- 22EFridge fan error — the fresh-food evaporator fan is iced, jammed, or failed.
- 21EFreezer fan error — the freezer evaporator fan is iced, jammed, or failed.
- 5EFridge defrost sensor error (often shown as 5E).
- 8EIce maker (freezer) sensor error (often shown as 8E).
- 33EIce pipe heater error — the ice maker fill tube is not heating.
- 39EIce maker function error — harvest or fill did not complete.
- 40EIce room fan error — the ice-maker compartment fan is not running.
- 88 88Communication fault after a power disruption (shown as 88 88).
- 85CLow voltage warning — a brief brownout was detected. Press OK for 3 seconds to clear.
- 83ECompressor abnormal current — often after a power surge.
Oven / Range error codes
- C24Oven temperature is rising too fast — the cooktop vent is often blocked by a pan.
- CF0Communication error between range control boards.
- C10Self-diagnosis temperature-sensor notice — ignore if the oven heats normally during cooking.
- doorOven door is not closed, or the door plunger switch is stuck.
- tEStDemo mode is on — the oven and electric cooktop will not heat.
- bAd LinEPower connection is not wired or plugged in correctly.
- dEOven partition / divider is missing or not seated for Twin Cook (often shown as dE or dC).
Dishwasher error codes
- 4EWater supply error — the dishwasher is not getting water at the pressure or temperature it needs.
- 5CDrain error — the dishwasher cannot empty. Clean the filter and check the drain hose.
- 3CPump operation error — the wash or drain pump failed to run.
- 7EWaterwall reflector error — the reflector cannot move freely.
- 9ELow water level error — not enough water in the tub to wash.
- IEClogged filter or high-temperature heater error, depending on the model family.
- LCLeakage error — the leak sensor detected moisture. The dishwasher will keep draining to protect the floor.
- OCOver-level water error — there is more water in the tub than there should be.
- CECommunication error — the control panel cannot talk to the rest of the dishwasher.
- HEHeater error (often shown as HE) — the dishwasher cannot heat wash water correctly.
- tETemperature sensor error (often shown as tE) — the dishwasher cannot read water temperature.
- bEButton error — the panel detects a stuck key.
Microwave error codes
- C20Temperature sensor error — the sensor is open or shorted.
- C21Temperature sensor or over-temperature error. Unplug and let the unit cool before restarting.
- C22Temperature sensor error — the sensor circuit is out of range.
- C-10Gas / easy-cook / PH sensor error (shown as C-10).
- C-F0Communication error between microwave control boards (shown as C-F0).
- CD0Door or key error — a key was held too long, or the door switch is not reading closed.
- SEKey short — a touch key was pressed for more than 10 seconds. Clean and dry the pad.
- TETouch-key communication error (often shown as TE).
- E24Over-temperature error — the cavity got hotter than the limit.
- E36Door open error — close the door firmly and retry.