Maytag washer F21 error code
Washer
Reviewed August 2025 · sources below
Maytag washer F21 means the drain cycle exceeded its time limit — water is leaving too slowly or not at all. Front-load Maytag washers share this code with Whirlpool-platform models. The pump filter (coin trap) and drain hose routing cause most F21 errors; the drain pump itself fails less often on machines under ten years old.
Buy the replacement part
MPN: W10876600
$37.99
Safe to keep using?
Use caution
This issue may worsen during use — limit operation and address promptly.
- • Turn off the water supply before disconnecting hoses.
5 product recalls may apply
Brand-level matches — verify your model.
Show
5 product recalls may apply
Brand-level matches — verify your model.
- Notice
Whirlpool Recalls Stacked Commercial Clothes Dryers Sold Under the ADC Brand Due to Fire Hazard (Recall Alert)
Sep 2023 · Confirm your model
- Notice
Maytag Recalls Dishwashers Due to Fire Hazard
Jun 2010 · Confirm your model
- Notice
Maytag Recalls Dishwashers Due to Fire Hazard
Feb 2007 · Confirm your model
- Notice
CPSC, Whirlpool Corporation Announce Recall of Dishwashers
Feb 2005 · Confirm your model
- Notice
CPSC, Whirlpool Announce Recall of Washer and Gas Dryer Units
Jul 2002 · Confirm your model
Likely causes
Many codes resolve with cleaning, resetting, or reconnecting.
Check: Power-cycle the appliance and check for obvious blockages or loose connections.
Est. cost: $0–$0
Wear or electrical failure of an internal part.
Check: If basic checks fail, the faulty component likely needs replacement.
Est. cost: $0–$75
What it means
Long drain error.
Repair video
How to fix it
- Unplug the washer and locate the pump filter behind the lower front panel — place towels under the access door.
- Drain into a pan, remove the filter, and clear debris from the pump impeller.
- Inspect the drain hose for kinks and confirm it is not inserted more than 4.5 inches into the standpipe.
- Reinstall the filter, restore power, and run Drain & Spin with an empty tub.
- If F21 persists, test the drain pump — humming with no flow means a failed pump.
Call a pro when: Call a pro if water leaks from the filter after install or the tub still holds water after pump replacement.
FAQ
What does F21 mean on a Maytag washer?
F21 is a long-drain fault — the washer could not empty the tub in time.
How do I reset Maytag F21?
Clear the drain path, unplug for 5 minutes, and run a spin cycle. F21 clears after successful drainage.
Do I need a pump for F21?
Clean the filter first — replace the pump only if it fails to move water after the path is clear.
Is F21 the same on Whirlpool washers?
Yes — Whirlpool-platform front-load washers use F21 for the same drain timeout fault.
Maytag F21 on specific models
Other Maytag Washer codes
Prevent this problem next time
- Follow manufacturer maintenance schedule
- Address small issues before they worsen
Sources
Manufacturer meaning
Long drain error.
FixApplianceCode guidance
Start with basic checks for Maytag F21 before ordering parts.
Source type: Part database
Source: ModelPartFinder + FixApplianceCode editorial
Last reviewed: 2026-09-21
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FixApplianceCode may earn a commission when you purchase through qualifying links, at no additional cost to you. Affiliate disclosure