EI24ID80WS i10 error
Your Electrolux EI24ID80WS is showing i10. Before replacing parts, confirm the model tag matches EI24ID80WS: Open the door and look on the inner door edge or left/right side of the tub opening. On this Electrolux dishwasher, i10 means Low water level — the tub is not filling enough. Check the supply valve, inlet hose, and water inlet valve. The steps below follow the field-service order for the EI24ID80WS platform — not the generic Electrolux i10 page. Cross-check part fit with EI24ID80WS before ordering — use the model-specific parts diagram. If the code cleared after a reset but returned mid-cycle, treat that as a confirmed fault rather than a one-time glitch.
Buy the replacement part
Fix steps
- Verify the model tag reads EI24ID80WS — Open the door and look on the inner door edge or left/right side of the tub opening.
- Reset i10: unplug the dishwasher or switch off the breaker for 5 minutes, then restore power.
- Remove and clean the tub filter, confirm the inlet valve screen is clear, and check the door gasket before assuming a pump or valve failure for i10.
- Cross-check part fit with EI24ID80WS before ordering — use the model-specific parts diagram.
- Run a test cycle after repair. If the code returns, use the compatible parts below or the full brand code guide.
Guided repair checklist
Complete the safe checks one at a time. Progress is saved for this browser so you can continue later.
0 of 5 checks recorded
Recommended next action
Start with this check before considering replacement parts.
Check 1 of 5
Verify the model tag reads EI24ID80WS — Open the door and look on the inner door edge or left/right side of the tub opening.
Did the repair resolve the issue?
Restoring repair progress…
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FAQ
What does i10 mean on a Electrolux EI24ID80WS?
Low water level — the tub is not filling enough. Check the supply valve, inlet hose, and water inlet valve.
How do I reset i10 on a EI24ID80WS?
Unplug the dishwasher or switch it off at the breaker for 5 minutes, then restore power and restart. If i10 returns on the EI24ID80WS, the underlying fault is still present.
What part do I need for EI24ID80WS i10?
Try the reset and troubleshooting steps first. i10 on the EI24ID80WS is not always a failed part.
Is i10 on the EI24ID80WS easy to fix?
Many owners fix this themselves with basic tools. Start with the reset and steps above, then check compatible parts below.