MDB4949SKZ H20 error
Your Maytag MDB4949SKZ is showing H20. Before replacing parts, confirm the model tag matches MDB4949SKZ: Open the door and look on the inner door edge or left/right side of the tub opening. On this Maytag dishwasher, H20 means Not detecting water — confirm the supply valve is open and the inlet hose is not kinked. The steps below follow the field-service order for the MDB4949SKZ platform — not the generic Maytag H20 page. Cross-check part fit with MDB4949SKZ before ordering — use the model-specific parts diagram. If the code cleared after a reset but returned mid-cycle, treat that as a confirmed fault rather than a one-time glitch.
Buy the replacement part
Fix steps
- Verify the model tag reads MDB4949SKZ — Open the door and look on the inner door edge or left/right side of the tub opening.
- Reset H20: unplug the dishwasher or switch off the breaker for 5 minutes, then restore power.
- Remove and clean the tub filter, confirm the inlet valve screen is clear, and check the door gasket before assuming a pump or valve failure for H20.
- Cross-check part fit with MDB4949SKZ before ordering — use the model-specific parts diagram.
- Run a test cycle after repair. If the code returns, use the compatible parts below or the full brand code guide.
Guided repair checklist
Complete the safe checks one at a time. Progress is saved for this browser so you can continue later.
0 of 5 checks recorded
Recommended next action
Start with this check before considering replacement parts.
Check 1 of 5
Verify the model tag reads MDB4949SKZ — Open the door and look on the inner door edge or left/right side of the tub opening.
Did the repair resolve the issue?
Restoring repair progress…
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FAQ
What does H20 mean on a Maytag MDB4949SKZ?
Not detecting water — confirm the supply valve is open and the inlet hose is not kinked.
How do I reset H20 on a MDB4949SKZ?
Unplug the dishwasher or switch it off at the breaker for 5 minutes, then restore power and restart. If H20 returns on the MDB4949SKZ, the underlying fault is still present.
What part do I need for MDB4949SKZ H20?
Try the reset and troubleshooting steps first. H20 on the MDB4949SKZ is not always a failed part.
Is H20 on the MDB4949SKZ easy to fix?
Many owners fix this themselves with basic tools. Start with the reset and steps above, then check compatible parts below.