GE washer E4 error code
Washer
Reviewed August 2025 · sources below
GE washer E4 signals the machine did not fill fast enough — similar to Samsung 4C. Both supply valves must be open and inlet screens at the wall and washer must be clear. On GFW550 front-load models sediment in the valve filters is common in homes with older plumbing.
Buy the replacement part
MPN: WH13X10024
$29.99
Safe to keep using?
Safe for limited use
No immediate safety hazard detected, but monitor during use.
- • Monitor the appliance during use and stop if symptoms worsen.
5 product recalls may apply
Brand-level matches — verify your model.
Show
5 product recalls may apply
Brand-level matches — verify your model.
- Notice
Generac Power Systems Expands Recall of Generac and DR Power Electric Start Pressure Washers Due to Risk of Serious Injury or Death from Carbon Monoxide Hazard; Includes Additional Models
May 2026 · Confirm your model
- Notice
Generac Power Systems Recalls Generac and DR Power Electric Start Pressure Washers Due to Carbon Monoxide Hazard
Apr 2022 · Confirm your model
- Notice
Sargent Art Recalls Craft Paints Due to Risk of Exposure to Bacteria
Oct 2016 · Confirm your model
- Notice
GE Appliances Recalls Top-Loading Clothes Washers Due to Fire Hazard
Sep 2016 · Confirm your model
- Notice
Viking Range Expands Dishwasher Recall Due to Fire Hazard
Aug 2015 · Confirm your model
Likely causes
The shutoff valve is closed, or the inlet hose is crushed behind the appliance.
Check: Confirm household water is on, fully open the supply valve, and straighten the inlet hose.
Est. cost: $0–$0
The valve solenoid can stick or fail after years of use, so the tub never fills.
Check: If the supply is open and the hose screen is clean, the water inlet valve likely needs replacement.
Est. cost: $25–$75
What it means
Water fill timeout.
How to fix it
- Confirm hot and cold valves behind the washer are fully open.
- Unplug, shut off water, disconnect hoses, and rinse inlet screens on both sides.
- Reconnect, check for leaks, restore power, and start a fill cycle — you should hear water within 30 seconds.
- If water enters slowly at the wall, house pressure may be low — test other fixtures.
- Replace the water inlet valve (WH13X10024 on many GE washers) only if pressure is good but the tub does not fill.
Call a pro when: Call a plumber for whole-house low pressure or a technician if the valve buzzes with no fill.
FAQ
What does E4 mean on GE washer?
E4 is a fill timeout — the washer did not detect adequate water flow.
How do I reset GE E4?
Restore water supply, unplug 5 minutes, and restart. E4 clears after a normal fill.
Do I need WH13X10024 for E4?
Only if inlet screens are clean and valves are open but the drum still does not fill.
Can frozen lines cause E4?
Yes in garages or exterior walls — thaw lines before replacing parts.
GE E4 on specific models
Other GE Washer codes
Prevent this problem next time
- Keep the water supply valve fully open
- Do not pinch the inlet hose during installation
Sources
Manufacturer meaning
Water fill timeout.
FixApplianceCode guidance
Open the supply valve and check the inlet hose before replacing the water inlet valve.
Source type: Part database
Source: ModelPartFinder + FixApplianceCode editorial
Last reviewed: 2026-09-21
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FixApplianceCode may earn a commission when you purchase through qualifying links, at no additional cost to you. Affiliate disclosure