Kenmore refrigerator F8EC error code
Refrigerator
Reviewed August 2025 · sources below
Kenmore F8EC signals the ice maker or water valve circuit did not complete its expected sequence — the display may show F8 EC on some panels. On WRF535/MFI2570 ice-maker kits, a loose harness at the freezer door hinge or a failed water inlet valve (W10884390) is common before assuming a bad ice maker module.
Buy the replacement part
MPN: W10884390
$79.99
Safe to keep using?
Stop using
No immediate safety hazard detected, but monitor during use.
- • Unplug the appliance before inspection.
- • Do not continue using the appliance until the cause is identified.
1 product recall may apply
Brand-level matches — verify your model.
Show
1 product recall may apply
Brand-level matches — verify your model.
- Notice
CPSC And Amana Work To Fix Refrigerator Shock Hazard
Nov 1994 · Confirm your model
Likely causes
Many codes resolve with cleaning, resetting, or reconnecting.
Check: Power-cycle the appliance and check for obvious blockages or loose connections.
Est. cost: $0–$0
Wear or electrical failure of an internal part.
Check: If basic checks fail, the faulty component likely needs replacement.
Est. cost: $0–$100
What it means
Ice or water system fault — the ice maker or water valve circuit did not complete.
How to fix it
- Unplug the refrigerator and inspect the freezer door hinge wiring harness — repeated door use can loosen connectors.
- Confirm the water supply valve behind the fridge is fully open and the line is not kinked.
- Check for frozen fill tube at the ice maker — a blocked tube stops harvest and triggers F8EC.
- Inspect the ice maker wiring at the module and the water valve terminals for corrosion.
- Restore power and run a manual ice maker harvest test per your manual if F8EC persists.
Call a pro when: Call a technician if you see active leaking at the water valve, smell burning from the ice maker area, or F8EC returns after valve replacement.
FAQ
What does F8EC mean on a Kenmore refrigerator?
F8EC is an ice or water system fault — the ice maker or water valve circuit did not complete properly.
How do I reset Kenmore F8EC?
Power off 5 minutes, confirm water supply, and check the door hinge harness. Clear any ice blocking the fill tube.
What part fixes Kenmore F8EC?
Often the water inlet valve W10884390 or ice maker module after harness checks. Verify model-specific part numbers.
Does F8EC stop cooling?
Usually not — F8EC is isolated to the ice/water system, but fix it promptly to avoid leaks at the valve.
Kenmore F8EC on specific models
Other Kenmore Refrigerator codes
Prevent this problem next time
- Follow manufacturer maintenance schedule
- Address small issues before they worsen
Sources
Manufacturer meaning
Ice or water system fault — the ice maker or water valve circuit did not complete.
FixApplianceCode guidance
Start with basic checks for Kenmore F8EC before ordering parts.
Source type: Part database
Source: ModelPartFinder + FixApplianceCode editorial
Last reviewed: 2026-08-24
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FixApplianceCode may earn a commission when you purchase through qualifying links, at no additional cost to you. Affiliate disclosure