Kenmore dishwasher F9E1 error code
- Dishwasher
Kenmore dishwasher F9E1 means the tub did not drain in time — standing water remains after the cycle. On WDT750SAHZ and similar models, a clogged filter sump, kinked drain hose, or blocked air gap under the sink causes most F9E1 codes before the drain pump fails. Remove the lower spray arm and filter assembly first — food sludge in the sump is the most common fix.
Reviewed August 2025 · sources below
Safe to keep using?
Stop using
Severe overheating requires stopping use until the cause is identified.
- • Unplug the appliance before inspection.
- • Turn off the water supply before disconnecting hoses.
- • Do not continue using the appliance until the cause is identified.
Next step
Still seeing F9E1?
Show a photo or describe the symptom. Answer a few safety-first questions and see whether a part is needed.
Free guided checks · No account required · Don’t open live electrical, gas, or refrigerant equipment
How to fix F9E1
- Cancel the cycle and remove standing water with towels or a cup from the tub bottom.
- Remove the lower filter and spray arm — clear debris from the sump and chopper blade area.
- Check the drain hose and air gap at the sink — blow through the air gap to confirm it is not clogged.
- Run a drain-only cycle and listen for the drain pump — humming with no water movement suggests a failed pump.
- Replace the drain pump (W10876537 on many models) only if the sump is clear but water still does not leave the tub.
Call a pro when: Call a plumber if the sink drain is slow at all fixtures, or a technician if the pump hums but does not drain.
What F9E1 means
Long drain — the dishwasher is not emptying. Clean the filter and check the drain hose and disposer knockout.
Likely causes
Many codes resolve with cleaning, resetting, or reconnecting.
Check: Power-cycle the appliance and check for obvious blockages or loose connections.
Est. cost: $0–$0
Wear or electrical failure of an internal part.
Check: If basic checks fail, the faulty component likely needs replacement.
Est. cost: $0–$75
Professional assistance recommended
This issue may be unsafe for DIY repair. Follow the safety guidance above and contact a qualified technician.
Questions about F9E1
What does F9E1 mean on a Kenmore dishwasher?
F9E1 is a drain timeout — water remained in the tub after the drain cycle finished.
How do I reset Kenmore dishwasher F9E1?
Clear the filter sump, fix hose routing, power off 5 minutes, then rerun. F9E1 clears after successful drainage.
Do I need a pump for F9E1?
Clean the sump first — pump replacement is needed only if water does not drain with a clear path.
Can a clogged air gap cause F9E1?
Yes — a blocked air gap stops siphon drainage even when the pump runs.
Kenmore F9E1 on specific models
Other Kenmore Dishwasher codes
Prevent this problem next time
- Follow manufacturer maintenance schedule
- Address small issues before they worsen
Sources
Manufacturer meaning
Long drain — the dishwasher is not emptying. Clean the filter and check the drain hose and disposer knockout.
FixApplianceCode guidance
Start with basic checks for Kenmore F9E1 before ordering parts.
Source type: Part database
Source: ModelPartFinder + FixApplianceCode editorial
Last reviewed: 2026-10-23
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
As an Amazon Associate I earn from qualifying purchases. Some links may also earn other retailer commissions, at no additional cost to you. Affiliate disclosure