Samsung dryer HE error code
Dryer
Reviewed August 2025 · sources below
Samsung dryer HE indicates a heating fault — the drum may turn while exhaust air stays cool. On DV45R6100 and similar electric models, a half-tripped 30A breaker causes HE before the element fails. Gas models show HE when the igniter or gas supply is interrupted. Confirm full 240V at an electric dryer before replacing the heating element (DC47-00018A).
Buy the replacement part
MPN: DC47-00018A
$44.99
Safe to keep using?
Stop using
No immediate safety hazard detected, but monitor during use.
- • Unplug the appliance before inspection.
- • Do not continue using the appliance until the cause is identified.
Likely causes
Many codes resolve with cleaning, resetting, or reconnecting.
Check: Power-cycle the appliance and check for obvious blockages or loose connections.
Est. cost: $0–$0
Wear or electrical failure of an internal part.
Check: If basic checks fail, the faulty component likely needs replacement.
Est. cost: $0–$100
What it means
Heating error — dryer not heating properly.
Repair video
How to fix it
- Reset the 30A double-pole breaker fully OFF then ON for electric dryers.
- Run a timed dry and feel the exhaust within two minutes — no warmth means a true heating fault.
- For electric: test the heating element and thermistor for continuity per your model diagram.
- For gas: confirm the gas valve is on and listen for igniter clicking — no click may mean a failed igniter.
- Replace the element or igniter only after ruling out low voltage at the terminal block.
Call a pro when: Call an electrician for repeated breaker trips, or a technician for gas smell or no igniter activity.
FAQ
What does HE mean on Samsung dryer?
HE is a heating error — the dryer cannot produce heat during the cycle.
Is HE the same as HC?
Related heating faults — both point to heat circuit problems; check voltage first on electric models.
How do I reset Samsung HE?
Reset the breaker, power off 5 minutes, and retry. HE clears after successful heating.
What part fixes Samsung HE?
Often the heating element (DC47-00018A) on electric models or the igniter on gas models after voltage checks.
Samsung HE on specific models
Other Samsung Dryer codes
Prevent this problem next time
- Follow manufacturer maintenance schedule
- Address small issues before they worsen
Sources
Manufacturer meaning
Heating error — dryer not heating properly.
FixApplianceCode guidance
Start with basic checks for Samsung HE before ordering parts.
Source type: Part database
Source: ModelPartFinder + FixApplianceCode editorial
Last reviewed: 2026-09-22
Repair guidance is for informational purposes only. We do not guarantee that any fix will resolve your issue, and you assume all risk when following these steps. Terms & disclaimer
FixApplianceCode may earn a commission when you purchase through qualifying links, at no additional cost to you. Affiliate disclosure